SICONOFLOOR ROADWAY

NEED HELP?

Our specialists will help you find the best solution for your investment.

Go to contact

Description of the product

The materials of the Siconofloor Roadway system are intended to be used for insulating surfaces of pedestrian walkways, cycle paths, technical paths, footbridges, car parks, on steel or concrete bridges,drawbridges and modular bridges and on all concrete and steel surfaces.

Downloads

Technical Sheet of the system IBDiM National Technical Assessment Siconfloor Roadway 130 Siconfloor Roadway 160 Siconofloor Roadway BC Siconofloor Roadway Finisher Siconfloor Roadway 150

Application

The materials included in the Siconofloor Roadway system are intended for

performing insulation on walking surfaces, cycle paths, technical paths, footbridges, car parks, on steel or concrete bridges, drawbridges and modular bridges and on all concrete and steel surfaces.

Mechanical properties of Siconofloor Roadway system thickness 5.0 mm

The adhesion to concrete substrate is ≥2 MPa according to IBDiM procedure PB/TM-1/6:2016
The water capacity reduction ratio is 100% according to IBDiM PB-TM-X5:2012
Adhesion to concrete substrate after frost test after 200 freezing cycles in air and defrosting in water at:-18oC/+18oC according to IBDiM procedure PB/TM-1/6:2016 is ≥1,5 Mpa
The abrasion is 6042 mm3/5000mm2 according to PN EN 1338:2005+AC:2007
Light load curing time of 24 h at 25 oC/ Full load/ 7 days

COOPERATION WITH SICON